FLAT WALL INSTALLATIONS: 

    CORNER INSTALLATIONS: 

A: STOVE TO BACKWALL:
   SINGLE-WALL STOVEPIPE....... 15"
   DOUBLE-WALL STOVEPIPE........ 7"
   MANUFACTURED HOUSING*....... 12"
   ALCOVE*..................... 11" 

G: STOVE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE...... 10"
   DOUBLE-WALL STOVEPIPE....... 3"
   MANUFACTURED HOUSING*....... 8" 

B: STOVE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE....... 14"
   DOUBLE-WALL STOVEPIPE....... 12"
   MANUFACTURED HOUSING*....... 12"
   ALCOVE*..................... 12"    

H: CENTERLINE PIPE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE.. 22-5/8"
   DOUBLE-WALL STOVEPIPE.. 15-5/8"
   MANUFACTURED HOUSING*.. 20-5/8" 

C: CENTERLINE PIPE TO BACKWALL:
   SINGLE-WALL STOVEPIPE... 20-3/4"
   DOUBLE-WALL STOVEPIPE... 12-3/4"
   MANUFACTURED HOUSING*... 17-3/4"
   ALCOVE*................. 16-3/4  

I: DIAGONAL FROM CORNER TO FRONT LOP:
   SINGLE-WALL STOVEPIPE...... 60"
   DOUBLE-WALL STOVEPIPE...... 50"
   MANUFACTURED HOUSING*...... 57" 

D: CENTERLINE PIPE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE....... 26"
   DOUBLE-WALL STOVEPIPE....... 24"
   MANUFACTURED HOUSING*....... 24"
   ALCOVE*..................... 24" 

J: CORNER TO EDGE OF HEARTH:
   SINGLE-WALL STOVEPIPE...... 55"
   DOUBLE-WALL STOVEPIPE...... 48"
   MANUFACTURED HOUSING*...... 53" 

E: MINIMUM HEARTH WIDTH........ 36" 

L: WIDTH OF FRONT LOP......... 36" 

F: BACKWALL TO FRONT OF HEARTH:
   SINGLE-WALL STOVEPIPE... 48-1/2"
   DOUBLE-WALL STOVEPIPE... 40-1/2"
   MANUFACTURED HOUSING*... 45-1/2"
   ALCOVE*................. 44-1/2" 

 * DOUBLE-WALL PIPE IS REQUIRED FOR ALCOVE
   AND MANUFACTURED HOUSING INSTALLATIONS 

COMBUSTIBLE ALCOVE DIMENSIONS:  
MINIMUM 50" Wide X 90" Tall
MAXIMUM 48" Deep 

OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACE

Insert a length of 4" rigid or flexible aluminum intake pipe into the knockout hole in the bottom of the air plenum and extend it down through a 4-1/8" hole in the floor, terminating below the floor insulation. Caulk around the intake pipe and use silicone cement to glue a piece of 1/4" wire rodent mesh to the bottom.

OUTSIDE AIR SUPPLIED THROUGH BACKWALL

Insert a length of 4" rigid or flexible aluminum pipe into the knockout hole in the bottom of the air plenum and elbow back through a 4-1/8" hole in the outside wall behind the stove. Attach a 4" dryer vent termination on the outside of the wall, removing the flapper and substituting a piece of 1/4" rodent mesh cemented in place.