FLAT WALL INSTALLATIONS: 

    CORNER INSTALLATIONS: 

A: STOVE TO BACKWALL:
   SINGLE-WALL STOVEPIPE.... 12"
   DOUBLE-WALL STOVEPIPE..... 5"
   MANUFACTURED HOUSING*..... 8"
   ALCOVE*.................. 10" 

G: STOVE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE... 11"
   DOUBLE-WALL STOVEPIPE.... 4"
   MANUFACTURED HOUSING*.... 8" 

B: STOVE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE.... 18"
   DOUBLE-WALL STOVEPIPE.... 14"
   MANUFACTURED HOUSING*.... 16"
   ALCOVE*.................. 16" 

H: CENTERLINE PIPE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE... 25"
   DOUBLE-WALL STOVEPIPE... 18"
   MANUFACTURED HOUSING*... 22" 

C: CENTERLINE PIPE TO BACKWALL:
   SINGLE-WALL STOVEPIPE.... 22"
   DOUBLE-WALL STOVEPIPE.... 15"
   MANUFACTURED HOUSING*.... 18"
   ALCOVE*.................. 20" 

I: DIAGONAL FROM CORNER TO FRONT LOP:
   SINGLE-WALL STOVEPIPE... 67"
   DOUBLE-WALL STOVEPIPE... 57"
   MANUFACTURED HOUSING*... 63" 

D: CENTERLINE PIPE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE.... 30"
   DOUBLE-WALL STOVEPIPE.... 26"
   MANUFACTURED HOUSING*.... 28"
   ALCOVE*.................. 28" 

J: CORNER TO EDGE OF HEARTH:
   SINGLE-WALL STOVEPIPE... 60"
   DOUBLE-WALL STOVEPIPE... 53"
   MANUFACTURED HOUSING*... 57" 

E: MINIMUM HEARTH WIDTH..... 35" 

L: WIDTH OF FRONT LOP...... 25" 

F: BACKWALL TO FRONT OF HEARTH:
   SINGLE-WALL STOVEPIPE... 53"
   DOUBLE-WALL STOVEPIPE... 46"
   MANUFACTURED HOUSING*... 49"
   ALCOVE*................. 51" 

 * DOUBLE-WALL PIPE IS REQUIRED FOR ALCOVE
   AND MANUFACTURED HOUSING INSTALLATIONS 

COMBUSTIBLE ALCOVE DIMENSIONS: 

MINIMUM 57" Wide
MINIMUM 90" Tall
MAXIMUM 48" Deep 

Location of 4" Outside Air Knockout - Top View

OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACE

Insert a length of 4" rigid or flexible aluminum intake pipe into the knockout hole in the bottom of the air plenum and extend it down through a 4-1/8" hole in the floor, terminating below the floor insulation. Caulk around the intake pipe and use silicone cement to glue a piece of 1/4" wire rodent mesh to the bottom.

OUTSIDE AIR SUPPLIED THROUGH BACKWALL

Insert a length of 4" rigid or flexible aluminum pipe into the knockout hole in the bottom of the air plenum and elbow back through a 4-1/8" hole in the outside wall behind the stove. Attach a 4" dryer vent termination on the outside of the wall, removing the flapper and substituting a piece of 1/4" rodent mesh cemented in place.