1: Locate Both Rear Log Pins

2: Install Log A onto Rear
Log Pins, making sure log
is pressed up to brick panel.

3: Locate Ember Bed Pins

4: Install Ember Bed B onto
Ember Bed Pins, making
sure to press down firmly

5: Install Log C so that the "Y"
of Log C is sitting directly behind
the pin of Log B as shown below.

6: Lean the top of Log C
onto Log A. The top of
Log C should end up 2"
left of firebox centerline

7: Install Log D so the bottom of
Log D is sitting on the Shelf
Bump-outs on Ember Log B.

8: Lean the top of Log D
against the backwall,
resting on top of Log C

9: Place the bottom rear corner
of Log E on the flat surface to
the left side of Log A

10: Lean the top edge of
Log E forward so it rests
on the left edge of Log D

11: Place the bottom of Log F in
front of the rear burner,
to the right of Log A

12: Lean the top of Log F
against the knot on Log C

13: Grasp Log G as shown,
with the "Y" pointing up.
Lower in place so the back
of Log G stands on the
rear burner tube

14: Lean the "Y" of Log G
forward to rest on Log C

To finsh:

• Place small coals over front burner in a single layer.

• Place large coals randomly, leaving about 1" between them.

• Pull Inswool into small pieces and scatter over the front burner coals in a single layer.